English

Aerosol Can Manufacturing Process

Our aerosol cans are made on a continuous line. Each stage below is a short video from the factory floor, in the order the can actually travels: from the raw aluminium coil to the pallet in the warehouse.

  1. Raw Material Preparation

    Aluminium coil and slug arrive at the plant with mill certificates. Thickness, hardness and surface condition are checked before the material is released to the line, so nothing is formed from stock that has not passed incoming inspection.

  2. Stamping Forming

    The coil is fed into the press, and a blank is cut and formed into a shallow cup in the first strokes. Tooling is set for the can diameter and shoulder profile being produced, and the first parts are dimensionally checked before the line runs on.

  3. Deep Drawing

    Further drawing stages stretch the cup into a tall, seamless one-piece body, with wall thickness and concentricity held to tolerance. Because the body is drawn in one piece, there is no side seam to leak.

  4. Aluminum Can Cleaning

    Bodies pass through a cleaning stage that removes forming lubricants and metal fines, followed by a rinse and dry. A clean, evenly wetted surface is what lets the internal coating bond properly in the next step.

  5. Internal Coating

    An internal lacquer is applied to form a thin, continuous barrier between the aluminium and the product. This is the layer that keeps the formulation from reacting with the metal, and it matters most for food, cosmetic and personal care contents.

  6. Conveyor Transfer

    Can bodies move between stations on overhead and chain conveyors, so the line runs continuously without manual handling. Transfers are timed to keep every downstream stage fed at a steady rate.

  7. Base Coating

    An opaque base coat is applied and cured to give the decoration a uniform background. Without it the printed colours would read differently over bare metal, and the final shade would not match the approved reference.

  8. Color Printing

    Decoration is printed in-house by offset lithography, colour-matched against your approved Pantone reference, then sealed with a varnish in the finish you specify, gloss or matt. In-line checks keep colour and registration within tolerance across the whole run.

  9. Can Necking

    The open end of the body is progressively reduced to form the neck that accepts the valve. Necking gives the can the exact valve opening the product needs, while keeping the body strong enough for pressure and stacking.

  10. Automatic Packaging

    Finished cans are counted, stacked and packed by machine into trays or cartons to the pack pattern you specify. Each batch is checked and labelled before release, so it can be traced back through the line.

  11. Warehouse storage

    Packed cans are moved to the warehouse and stored under cover, on flat ground and away from moisture. Stock leaves in the same condition it came off the line, ready for your filling operation.

Want this line to run your own design? Send us your artwork and specification.